We repair garage doors that stop during travel, move unevenly, make loud noises, or fail to respond to the opener. The springs carry the door’s weight: torsion springs sit above the header, while extension springs run alongside the tracks. The opener moves a properly balanced door; it cannot compensate for a broken spring or cable.
Our crew checks the rollers, hinges, lift cables, drums, tracks, bottom weather seal, opener, and photo-eye sensors. With the opener disconnected, we check the door near its midpoint; a balanced door should stay there rather than rise or fall. We also look for loose hardware, worn parts, and anything blocking the sensors. A narrow garage layout may limit access to the tracks, so we check the working space before choosing a repair.
We explain the fault and give an exact quote on site before work begins. Our truck carries common door and opener parts, plus tools for hardware adjustments and component replacement. Once repairs are complete, we cycle the door and assess its balance and safety reversal.
Signs You Need Garage Door Repair
- My door starts up, then stops.
- It reverses before it closes.
- The door shakes or runs crooked.
- I hear scraping, squealing, or a bang.
- The remote stopped working.
- The door feels heavy when I lift it by hand.
The Rockville Freeze Factor
Summer afternoons here average about 88°F, and heat inside a closed garage can affect how the door travels. When we repair a door, our crew checks the rollers, track alignment, and spring balance before making adjustments. A door that strains or reverses needs a careful inspection, not extra force.
About 42 inches of rain fall here in a typical year, so water and grit may gather near the garage floor. We inspect the bottom seal, hinges, and rollers for wear or debris. In an older garage with an uneven floor, we check where the door meets the ground before adjusting the seal or hardware.
How We Handle It
Describe what the door is doing
Someone on our team takes your call and asks when the trouble began, what the door does, and whether the wall control or remote works.
Inspect and quote
At the home, we inspect the door, hardware, opener, and safety sensors to find the cause. We explain the repair and provide a firm on-site quote; work begins only after you approve it.
Repair the fault
With your approval, we repair or replace the affected part and make any needed adjustments to the door or opener.
Check balance and reversal
Before leaving, we assess the door’s balance and cycle it through its full range. We also check the safety reversal by placing a 2×4 on the garage floor under the closing door; when the door touches the board, it should reverse within two seconds.
Starting Prices — Garage Door Repair
- Garage Door Spring Replacement per spring
- From $150
- Garage Door Cable Replacement per cable
- From $150
- Roller Replacement per set
- From $120
- Track Repair & Off-Track Door per door
- From $150
- Diagnostic Service Call $0 with a completed repair
- $0
Starting prices. A door has two lift cables and one or two springs; the exact price depends on the door, the hardware grade and how many parts are replaced, and is confirmed on site before any work starts.